Garage Raising

The tapping and sanding is done except for a few places where I had to re-apply joint compound. I'll finish sanding tomorrow and prime the walls and ceiling for painting.

Me after four hours of sanding. Now you know where all the sheetrock dust goes.

I finished painting the walls today and am happy with the color.

I got the trim installed around the west window. I haven't st the nails and filled the holes yet.

A shot of the door with casing installed also showin the electrical and the bench for my drill press which will be painted white.

This is a shot of the work bench I built for the Grinder, router table, scroll saw and bench vise. Also show is sufficient electrical outlet to run the equiptment. The benches are sturdy and I stood on them while sheet rocking, taping and painting.

The ceiling and walls taped, sanded and now primed and ready for painting.

I ran short of primer and had to postpone the preperation for painting until tomorrow.

Also the trim is installed on the north window.

Here is a shot of the shop door with the trim installed.

I painted the work bench today so will bolt the tools to the bench tomorrow. I am going to install a 1x4 back stop the length of the bench. That is why I got a little sloppy with the paint.

I also built the bench for the band saw and painted it as well.

Another shot of the bench showing the band saw bench and window.